You will be supplied with everything you need to fit this kit. 12V 140amp Voltage Sense Split Charge Relay. 1 x 250mm 110amp Red Starter Battery to fuse box lead. 1 x 4000mm 110amp Red Fuse box to relay lead (6mm to 6mm terminals).1 x 500mm 110amp Red Relay to fuse box lead (6mm to 6mm terminals). 1 x 250mm 110amp Red Fuse Box to Leisure Battery Lead (6mm to 8mm terminals). 1 x 1000mm 110amp Black Earth Cable. Spare terminals + Heat shrink pack for modifications if required. Positive & Negative 8mm post type battery terminals. 2 x Fuse Holders & 100amp Fuses including a spares. 15 x Cable ties + fixings to keep everything tidy. 2mtrs Split conduit to protect cables in Engine bay. Screws to fix fuse boxes & cable tie bases. High Quality HSS Drill Bit.
Easy to understand Fitting Instructions. Please note: The 5 mtrs of Red cable supplied in this split charge kit are made up of the 4 separate leads as described above. 1 x 12-Way Fuse Box. 1 x 250mm Red 110amp 16mm² Lead with M6-M8 Terminals. Red 110amp 16mm² Lead with M6-M6 Terminals (only 1 shown in picture).
1 x 250mm Red 110. Amp 16mm² Lead with M6-M6 Terminals (to use as positive link lead on fuse box).
1 x 1mtr Black 110amp 16mm² Lead with M8-M6 Teminals. 1 x strip link fuse holders + 2 x 100amp fuses. 2 x 6mm + 1 x 8mm Spare Copper Tube Terminals.
2 x red + 1 x Black Spare Heat Shrink to suite. 4 x each 5amp, 10amp, + 2 x each15amp & 20amp Blade Fuses. 25 x 4mm blue insulated ring terminals.
8 x screws to install fuse holders + fuse box. This type of split charge system is our simplest to install split charge system. All the leads are supplied ready made up for you to a very high standard. Simply install the two fuse boxes and the Voltage sense relay using the fixings supplied. Then simply connect all the ready made leads, following the very easy to understand supplied fitting instructions to install this very high quality and simple to install split charge system.The voltage sense relay simply detects the rise in voltage from you vehicles charging system when it exceeds 13.3v to allow you to charge your leisure battery(s) while your engine is running. When your engine is switched off and the battery voltage drops below 12.8v the relay will isolate your leisure battery(s) from your main starter battery so it does not drain your main starter battery and you will always be able to start your vehicle. All of the range of 140amp voltage sensitive relays are dual sensing meaning that if a charging voltage like through a mains charger or solar panel is applied to the leisure battery that exceeds the relay activation voltage of 13.3v it will activate the relay to allow this charging device to also maintain the starter battery. Relay activation voltage 13.3v. Relay isolation Voltage 12.8v. Voltage sense systems are especially suited for modern vehicles as this type of system does not need an ignition feed or any additional wiring into your vehicle but for modern Intelligent smart charging vehicles with Euro6 engines you will need to use a DC to DC charger. The item "5mtr Professional Split Charge Kit + 12 way fuse box for camper van wiring" is in sale since Tuesday, October 3, 2017. This item is in the category "Vehicle Parts & Accessories\Motorhome Parts & Accessories\Campervan & Motorhome Parts". The seller is "simplysplitcharge" and is located in millom. This item can be shipped worldwide.