Cadiveu Professional Plastica dos Fios Hair Plastic Surgery Smoothing System.. Cadiveu Plastic Wire Kit Heat Sealing Anti-Frizz 1L. The Cadiveu Thermal Sealing Kit is an intensive treatment that reduces volume, eliminates frizz and provides smooth, controlled yarn for up to 3 months.
It deeply nourishes and moisturizes the hair as well as giving incredible shine and strengthening the structure, preventing breakage. Cadiveu Plastic Yarn Step 1 Pre-Sealing Shampoo 1000ml: Deep cleans the hair and helps open the cuticle facilitating the penetration of the active principles of treatment. Cadiveu Plastic Yarn Step 2 Heat Sealing 1000ml: With the other products, it promotes the long lasting natural smooth effect on the hair and leaves the hair shiny and frizz-free. Cadiveu Plastic Wire Step 3 Sealant Mask 1000ml: Promotes maximum hydration of the wires reducing frizz and accentuating the smooth effect. Products are not available individually.
Treatment consisting of Arginine, Acai Extract and Acetic Acid (ph acid). Acai Extract: Rich in nutrients such as Vitamins, Essential Sugars and Emollient Oils. Its antioxidant and protective action promotes a complete regeneration of the hair, efficiently and prolonged hydration. Amino acids: balance the structure of the wires from aggressions caused by the excessive use of dryers and flat iron.Increases its suppleness and elasticity, leaving hair softer and extremely easy to comb. Phytonutrients: Nourish and protect hair, helping to regenerate damaged and worn parts. Acetic Acid Shampoo: Acidic acid may cause irritation and peeling of sensitized leather.
For this reason we recommend not to apply to pregnant women, people with sensitive leather and children under 12 years. Note: Offers about 35 applications. Certified Micro Quality Labs (USA) and Anvisa.The effect is prolonged with the use of Cadiveu Plastic Wire care products. It should not be applied to pregnant women, people with sensitive scalp and children. Try CADIVEU PROFESSIONAL PLASTIC WIRE HAIR PLASTIC SURGERY THERMAL SEAL (3 PRODUCTS) and check the results. Material needed: silicone gloves, dryer, board, plastic clips, fine comb, brush and plastic container. 1- Wash your hair with the Pre-Treatment Shampoo, massaging until foamy. Wash twice in case of virgin hair that is very resistant or very dirty. Let it act for 5 minutes and rinse completely. Attention: Do not rub the scalp. 2- Dry the hair in 80% with the dryer and finger aid. 3- Separate the hair into 6 parts (a vertical line separating the hair into two strands - right and left - and 3 horizontal sessions - neck, middle and front from the ears).
Secure each session in a bun with a clip. 4- Pour 20 to 40ml of Heat Seal in a container and put on the silicone gloves. 5- Start applying on a strand of the neck with the aid of the brush.Apply two fingers of the root to the base of the wick and pull the product to the ends with the comb. Make sure the product is on all wires. 6- Repeat the procedure with the side lock. 7- With the dryer in the cold jet, dry the two locks 100%.
It is important to dry two strands at a time with the cold jet. This prevents smoke formation and prevents the product from evaporating without effect. 8- Repeat the procedure from 5 to 7 on the two central strands of hair one at a time. 9- Finally, repeat the procedure 5 to 7 on the two front strands of hair, drying the strands back. It is important that neither the dryer wind nor the lint with the product come into contact with the face.In blonde, damaged or chemical hair the board temperature should not exceed 200 ° C. For normal, virgin or temperature resistant hair it should be at 230 ° C. 11- Divide the hair again into parts using barrettes. Separate a thin, linear strand and plank the length (without the tips) of the strand 10 times (200 ° C board) or 7 times (230 ° C board). 12- Prick the ends (without the length) of the hair up to 4 times (200 ° C board) or 2 times (230 ° C board). This way you avoid the artificial smooth effect on the tips. 13- Repeat this process (steps 11 and 12) for all strands of hair. The straight flat iron with respect to leather makes the strands naturally smooth from the root. 14- After plucking all the strands, rinse the hair well. 15- Apply the Restorative Mask on the wires gently massaging the strands.
Let it act for 5 minutes and rinse again. 16- Dry the hair with the dryer. Note: In case of relaxed or straightened hair, apply the Plastic Thermal Sealing of the wires after the chemical process. In the case of dyeing or toning, apply Plastic Thermal Yarn Sealing two days before or after dyeing to better fix the color pigments to the yarn. The item "Cadiveu Plastica dos Fios Straightener Brazilian Keratin Wires Treatment 3 x 1L" is in sale since Sunday, October 13, 2019.
This item is in the category "Health & Beauty\Hair Care & Styling\Relaxers & Straightening Prod". The seller is "lm_corporation" and is located in SP, . This item can be shipped worldwide.